Common Urinal Problems
APPEARANCE
Once fitted urinal waste outlets are normally left in place until the urinal bowl is replaced. After a while they get coated in uric salts and limescale on the inside with occasional cigarette burns on the outside. The addition of urinal blocks makes them look more unsightly.
SMELL
Caused by ‘bad’ bacteria in biofilm, uric sludge and limescale build up on the internal surface of the waste outlet and waste trap. Also caused by unhygienic seepage from the connection between the waste outlet and the waste trap
BLOCKAGES
Caused by build up of uric acid sludge, fragments of chemical blocks and limescale in the waste trap and pipe work
The solution
The Sani-Sleeve is a low cost consumable and can be retro-fitted to existing urinals as well as fitted to new units. Its odour locking design lines the internal surface of the waste outlet and trap which is a major source of unpleasant smells. Sani-Sleeve units are replaced quarterly to ensure that the bio enzymes that line the sleeve continue to work well, and to maintain a high standard of appearance.THIS KEEPS YOUR URINALS LOOKING AND SMELLING LIKE NEW!‘Good’ bacteria and enzymes in the Sani-Sleeve deal with the cause of smells and blockage. They feed on the uric salts, which become soluble and are washed away with the next flush.
The Sani-Sleeve prevents seepage from the connection between waste outlet and trap, because the plastic sleeve acts as a funnel, and crystal growth in joints is reduced. |
|
|
BEFORE Sani-Sleeve:

With Sani-Sleeve fitted:

|